Buy Direct From Us
Looking for those hard to find PC Boards? We have them cheaper than you can find elsewhere. If you see it cheaper, PLEASE give us a chance to beat that price for you. We have the widest variety of boards in the industry. If you don't see it, just ask. We have boards from .005" thick to double sided boards with 4 oz. of copper on each side.
ONLY available at INJECTORALL
Material Safety Data Sheet for Triso Flux Remover
Section I Hazardous Ingredients / Identity Information
Hazardous Components OSHA ACGIH Other Limits
(Specific Chemical Identity) PEL TLV
1,1,1-Trichloroethane ( 71-55-6 ) 350 PPM TWA 350 PPM TWA NA
Isopropanol ( 67-63-0 ) 400 PPM TWA 400 PPM TWA NA
Section II Physical / Chemical Characteristics
Boiling Point ( °F ) : ( concentrate ) 165
Specific Gravity ( H2O = 1 ): 1.28
Vapor Pressure @ 70° F: 100 psi
Halting Point: - 41° F
Vapor Density ( Air = 1 ): >1
Evaporation Rate: Solubility in water : About 34%
( Butyl Acetate = 1 ) : 0.35
Appearance & Odor: Clear colorless liquid with alcohol / ethereal odor
Section III Fire and Explosion Hazard Data
Flash Point ( °F ): NA
Flammability Limit: LET: NA UEL: NA
Extinguishing Media: Carbon Dioxide, dry chemical, foam, and water fog
Special Firefighting Procedures: Self-contained respiratory protection should be provided for firemen
fighting in buildings or confined areas.
Section IV Reactivity Data
Conditions to Avoid: NA
Hazardous Polymerization: Will not occur
Conditions to Avoid: NA
Incompatibility ( Material to Avoid ): Strong oxidizing agents and alkalies
Hazardous decomposition or products: Burns to form CO, CO2, HCL and possible traces of chlorine and phosgene
Section V Health Hazard Data
Health Hazards ( Acute & Chronic ): Prolonged overexposure can cause central nervous system depression. Minimal anesthetic effects may be seen in the range of 500-1000 PPM. Contact with membrane can cause moderate irritation.
IARC Monograph: No
OSHA Regulated: No
Signs and Symptoms of Exposure: Ingestion may cause abdominal cramps and diarrhea. Contact with skin can cause mild irritation and drying or flaking of skin.
Medical Conditions Generally Aggravated by Exposure: None Known
Emergency & First Aid Procedures: Move away from exposure source. Thoroughly wash contaminated eyes and skin with water. Give oxygen. Do not induce vomiting. Never give Adrenaline following overexposure.
Section VI Precautions for Safe Handling and Use
In Case Material is Released or Spilled: Use absorbent sweeping liquid to soak up material. Put into container.
Waste Disposal Method: Dispose of all waste in accordance with federal, state, and local regulations
Precautions to be taken in Handling or Storage: Keep away from heat, sparks, open flame or direct sunshine. Do not puncture or incinerate.
Other Precautions: Intentional misuse by deliberately concentrating and inhaling vapor contents can be harmful or fatal.
Section VII Control Measures
Respiratory Protection: Necessary for normal use
Local Exhaust: None
Mechanical ( general ): None
Protective Gloves: Necessary for normal use
Eye Protection: Safety goggles or face shield
Other Protective Clothing or Equipment: Not necessary for normal use
Work/Hygienic Practices: Wash hands after use
40 Diamond Drive, Plainview NY 11803
General Information: firstname.lastname@example.org
Copyright © 2003 Injectorall Electronics Corp.
visitors to this page since Last Modified: June 22, 2001